UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HALF SIZE

HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS ACTIVE CURRENT

SHARING SWITCHING POWER SUPPLIES

TPAC202P SERIES

FEATURES:

EUROCARD PACKAGE

CORRECTION

N+1 REDUNDANCY

SPECIFICATION

INPUT SPECIFICATION

Input Voltage: Typ. 90-264Vac.

Power Factor Correction: Meet Harmonic Correction

IEC 61000-3-2.Power Factor typ. 0.98-0.99.

Input Connector: Positronic 47-pin PCIH47M400A1.

Input Frequency: 47-63Hz.

Inrush Current: 6.85Arms at 230Vac 50Hz.

Input Current: 2.45A at 115Vac/1.13A at 230Vac.

Dielectric Withstand: Meet IEC 60950-1 regulation.

EMI: Meet EN 55022 / FCC Class A.

Hold-up Time: 16.8mS at 115Vac/230Vac.

Leakage Current: 0.45mA for IEC60950-1 Touch current.

Remote ON/OFF: Available at [INH#] & [EN#] pins.

Power Fail Signal: Available at [FAL#] pin.

Status LED: <Green> means valid input voltage.

<Amber> means a critical fault.

Thermal Protection (OTP): Installed NTC and

thermostat for thermal sensor at [DEG#] pin.

GENERAL SPECIFICATION

Efficiency: Typical 77 %.

Switching Frequency: 125K Hz.

Circuit Topology: Forward circuit.

Transient Response: Peak transient less than 105mV and

recovers within 0.084mS after 25% load-change.

Safety Standard: IEC 60950-1 Class I.

Construction: Eurocard 3U X 4HP X 160mm CompactPCI.

Operating Temperature: 0 to +50 °C at full load with

specified air flow. Derates linearly to 50% at +70 °C.

Storage Temperature: -40 to +85 °C.

Temperature Coefficient: Typ. ±0.02% / °C.

Cooling: At least 30CFM(800 LFM) moving air is required

to achieve full rating power 200W in a confined area.

Power Density: 7.4 Watts/ Cubic Inch.

NOTE: (1)All measurement are at nominal input, full load and +25°C unless otherwise specifications.

(2)Due to requests in market and advances in technology, specifications subject to change without notification.

In application.

OUTPUT SPECIFICATION

Output Voltage: See Ratings Chart.

Output Current: See Ratings Chart.

Output Wattage: Typ. 200W continuous.

Output Connector: Positronic 47-pin PCIH47M400A1.

Line Regulation: Typ. 0.1%.

Load Regulation: Typ. ±1%.

Total Regulation: Typ. ±1.5%.

Noise & Ripple: Typ. 1% peak to peak .

OVP: Built-in at all outputs.

Adjustability: Available at VO1,2&3.

Remote Sensing: Available at VO1,VO2 & VO3.

Hot-Swap: Available.

N+1 Redundancy: Installed with internal OR-ing diodes

at all outputs for N+1 redundancy operation.

Current Sharing: Third-wire current sharing at VO1,2 &3.

Power OK Signal: Available for all output.

Over Current Protection (OCP): Installed at each rail.

Overload Protection (OLP): Fully protected against output

overload or short circuit. Typical 115-135% max. load.

Consult the factory for special OLP setting.

Total Power International, Inc.

Total Power International, Inc. Toll Free: 877-646-0900(US) PH# 978-453-7272 www.total-power.com