www.ti.com

ELECTRICAL CHARACTERISTICS

TIMING REQUIREMENTS

SN74ALVCH16820

3.3-V 10-BIT FLIP-FLOP WITH DUAL OUTPUTS

AND 3-STATE OUTPUTS

SCES035G – JULY 1995 – REVISED OCTOBER 2004

over recommended operating free-air temperature range (unless otherwise noted)

PARAMETER

TEST CONDITIONS

MIN

MAX

UNIT

1.65 V to 3.6 V

1.65 V

1.2

2.3 V

2

2.3 V

1.7

V

2.7 V

2.2

3 V

2.4

3 V

2

1.65 V to 3.6 V

0.2

1.65 V

0.45

2.3 V

0.4

V

2.3 V

0.7

2.7 V

0.4

3 V

0.55

3.6 V

±5

µA

1.65 V

25

1.65 V

-25

2.3 V

45

2.3 V

-45

µA

3 V

75

3 V

-75

3.6 V

±500

3.6 V

±10

µA

3.6 V

40

µA

∆I

CC

3 V to 3.6 V

750

µA

Control inputs

3.5

3.3 V

pF

Data inputs

6

Outputs

3.3 V

7

pF

(1)

(2)

This is the bus-hold maximum dynamic current. It is the minimum overdrive current required to switch the input from one state to

another.

over recommended operating free-air temperature range (unless otherwise noted) (see Figure 1)

± 0.2 V

± 0.3 V

UNIT

MIN

MAX

MIN

MAX

MIN

MAX

MIN

MAX

Clock frequency

(1)

150

150

150

MHz

Pulse duration, CLK high or low

(1)

3.3

3.3

3.3

ns

Setup time, data before CLK

↑

(1)

1.7

1.8

1.4

ns

Hold time, data after CLK

↑

(1)

1.1

1.1

1

ns

(1)

This information was not available at the time of publication.

4