SS1352

Unipolar Hall Switch

5

V3.10

Nov 1, 2013

Output Behavior versus Magnetic Pole

Test Conditions (UA)

Test Conditions (SO)

OUT

High

Low

The SOT-23 device is reversed from the UA package. The SOT-23 output transistor will be turned on(drops low) in the presence of a

sufficiently strong South pole magnetic field applied to the marked face.

Application Information

It is strongly recommended that an external bypass capacitor be connected (in close proximity to the Hall sensor)

generated by the chopper stabilization technique. As is shown in the following

figure, a 0.1μF capacitor is

typical.

For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the V

When using a resistor, three points are important:

- the resistor has to limit the reverse current to 50mA maximum (V

- the resulting device supply voltage V

- the resistor has to withstand the power dissipated in reverse voltage condition (P

2

/R1)

When using a diode, a reverse current cannot flow and the voltage drop is almost constant (

≈0.7V).

Therefore, a 100

Ω/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.

Typical Three-Wire Application Circuit

When a weak power supply is used or when the device is intended to be used in noisy environment, it is

SS1352