ADM206–ADM211/ADM213

Rev. C | Page 8 of 16

Table 4. Pin Function Descriptions

Mnemonic

Function

Power Supply Input. 5 V ± 10%.

V+

Internally Generated Positive Supply (10 V nominal) on all parts, except ADM209 . The ADM209 requires an external 9 V to

13.2 V supply.

V–

Internally Generated Negative Supply (–10 V Nominal).

GND

Ground Pin. Must be connected to 0 V.

C+

(ADM209 only) External capacitor (+ terminal) is connected to this pin.

C–

(ADM209 only) External capacitor (– terminal) is connected to this pin.

C1+

(ADM206, ADM207, ADM208, ADM211, and ADM213) External Capacitor (+ terminal) is connected to this pin.

C1–

(ADM206, ADM207, ADM208, ADM211, and ADM213) External Capacitor (– terminal) is connected to this pin.

C2+

(ADM206, ADM207, ADM208, ADM211, and ADM213) External Capacitor (+ terminal) is connected to this pin.

C2–

(ADM206, ADM207, ADM208, ADM211, and ADM213) External Capacitor (– terminal) is connected to this pin.

each input.

Transmitter (Driver) Outputs. These are RS-232 levels (typically ± 10 V).

Receiver Inputs. These inputs accept RS-232 signal levels. An internal 5 kΩ pull-down resistor to GND is connected to each

input.

Receiver Outputs. These are TTL/CMOS levels.

EN/EN

Enable Input. Active low on ADM206, ADM209, and ADM211. Active high on ADM213. This input is used to enable/disable the

receiver outputs. With EN = low (EN = high ADM213), the receiver outputs are enabled. With EN = high (EN = low ADM213),

the outputs are placed in a high impedance state. This is useful for connecting to microprocessor systems.

SD/SD

Shutdown Input. Active high on ADM206 and ADM211. Active low on ADM213. With SD = high on the ADM206 and ADM211,

the charge pump is disabled, the receiver outputs are placed in a high impedance state, and the driver outputs are turned off.

With SD = low on the ADM213, the charge pump is disabled, the driver outputs are turned off, and all receivers, except R4

and R5, are placed in a high impedance state. In shutdown, the power consumption reduces to 5 µW.

NC

No Connect. No connections are required to this pin.

Table 5. ADM206 and ADM211 Truth Table

SD

EN

Status

Transmitters T1–T5

Receivers R1–R5

0

0

Normal Operation

Enabled

Enabled

0

1

Normal Operation

Enabled

Disabled

1

0

Shutdown

Disabled

Disabled

Table 6. ADM213 Truth Table

SD

EN

Status

Transmitters T1–T4

Receivers R1–R3

Receivers R4, R5

0

0

Shutdown

Disabled

Disabled

Disabled

0

1

Shutdown

Disabled

Disabled

Enabled

1

0

Normal Operation

Enabled

Disabled

Disabled

1

1

Normal Operation

Enabled

Enabled

Enabled