74ACQ464ASPC datasheet(8/10 Pages) FAIRCHILD

Il numero della parte	74ACQ464ASPC

Spiegazioni elettronici	Quiet Series??Octal Transceiver/Register with 3-STATE Outputs

Download	10 Pages

Scroll/Zoom	100%

Produttore elettronici	FAIRCHILD [Fairchild Semiconductor]

Homepage	http://www.fairchildsemi.com

Logo

8 / 10 page

www.fairchildsemi.com

8

FACT Noise Characteristics

The setup of a noise characteristics measurement is critical

to the accuracy and repeatability of the tests. The following

is a brief description of the setup used to measure the

noise characteristics of FACT.

Equipment:

Hewlett Packard Model 8180A Word Generator

PC-163A Test Fixture

Tektronics Model 7854 Oscilloscope

Procedure:

1. Verify Test Fixture Loading: Standard Load 50 pF,

500

Ω.

2. Deskew the HFS generator so that no two channels

have greater than 150 ps skew between them. This

requires that the oscilloscope be deskewed first. It is

important to deskew the HFS generator channels

before testing. This will ensure that the outputs switch

simultaneously.

3. Terminate all inputs and outputs to ensure proper load-

ing of the outputs and that the input levels are at the

correct voltage.

4. Set the HFS generator to toggle all but one output at a

frequency of 1 MHz. Greater frequencies will increase

DUT heating and effect the results of the measure-

ment.

5. Set the HFS generator input levels at 0V LOW and 3V

HIGH for ACT devices and 0V LOW and 5V HIGH for

AC devices. Verify levels with an oscilloscope.

FIGURE 5. Quiet Output Noise Voltage Waveforms

Note 20: VOHV and VOLP are measured with respect to ground reference.

Note 21: Input pulses have the following characteristics: f

= 1MHz,

tr = 3ns, tf = 3 ns, skew < 150 ps.

VOLP/VOLV and VOHP/VOHV:

• Determine the quiet output pin that demonstrates the

greatest noise levels. The worst case pin will usually be

the furthest from the ground pin. Monitor the output volt-

ages using a 50

Ω coaxial cable plugged into a standard

SMB type connector on the test fixture. Do not use an

active FET probe.

• Measure VOLP and VOLV on the quiet output during the

worst case transition for active and enable. Measure

VOHP and VOHV on the quiet output during the worst

case active and enable transition.

• Verify that the GND reference recorded on the oscillo-

scope has not drifted to ensure the accuracy and repeat-

ability of the measurements.

VILD and VIHD:

• Monitor one of the switching outputs using a 50

Ω coaxial

cable plugged into a standard SMB type connector on

the test fixture. Do not use an active FET probe.

• First increase the input LOW voltage level, VIL,until the

output begins to oscillate or steps out a min of 2 ns.

Oscillation is defined as noise on the output LOW level

that exceeds VIL limits, or on output HIGH levels that

exceed VIH limits. The input LOW voltage level at which

oscillation occurs is defined as VILD.

• Next decrease the input HIGH voltage level, VIH, until

the output begins to oscillate or steps out a min of 2 ns.

Oscillation is defined as noise on the output LOW level

that exceeds VIL limits, or on output HIGH levels that

exceed VIH limits. The input HIGH voltage level at which

oscillation occurs is defined as VIHD.

• Verify that the GND reference recorded on the oscillo-

scope has not drifted to ensure the accuracy and repeat-

ability of the measurements.

FIGURE 6. Simultaneous Switching Test Circuit

Codice articolo simile - 74ACQ464ASPC

Produttore elettronici	Il numero della parte	Scheda tecnica	Spiegazioni elettronici
Fairchild Semiconductor	74ACQ240	95Kb / 10P	Quiet Series. Octal Buffer/Line Driver with 3-STATE Outputs
	74ACQ240	274Kb / 11P	Quiet Series??Octal Buffer/Line Driver with 3-STATE Outputs
	74ACQ240PC	95Kb / 10P	Quiet Series. Octal Buffer/Line Driver with 3-STATE Outputs
	74ACQ240PCX	95Kb / 10P	Quiet Series. Octal Buffer/Line Driver with 3-STATE Outputs
	74ACQ240SC	95Kb / 10P	Quiet Series. Octal Buffer/Line Driver with 3-STATE Outputs

More results

Descrizione simile - 74ACQ464ASPC

Produttore elettronici	Il numero della parte	Scheda tecnica	Spiegazioni elettronici
National Semiconductor ...	54ACTQ646	186Kb / 9P	Quiet Series Octal Transceiver/Register with 3-STATE Outputs
Texas Instruments	54ACQ646	231Kb / 11P	[Old version datasheet] 54ACTQ646 Quiet Series Octal Transceiver/Register with 3-STATE Outputs
Fairchild Semiconductor	74ACQ543	93Kb / 9P	Quiet Series??Octal Registered Transceiver with 3-STATE Outputs
	74ACQ544	86Kb / 9P	Quiet Series??Octal Registered Transceiver with 3-STATE Outputs
	74AC646	72Kb / 10P	Octal Transceiver/Register with 3-STATE Outputs
	74F646	78Kb / 9P	Octal Transceiver/Register with 3-STATE Outputs
	74AC646	82Kb / 9P	Octal Transceiver/Register with 3-STATE Outputs
ON Semiconductor	MC74AC646	97Kb / 10P	Octal Transceiver/Register with 3-State Outputs March, 2015 ??Rev. 7
ON Semiconductor	MC74AC652	94Kb / 10P	Octal Transceiver/Register with 3-State Outputs March, 2015 ??Rev. 7
Fairchild Semiconductor	74AC648	73Kb / 7P	Octal Transceiver/Register with 3-STATE Outputs

More results

74ACQ464ASPC Scheda tecnica(PDF) 8 Page - Fairchild Semiconductor

74ACQ464ASPC Scheda tecnica(HTML) 8 Page - Fairchild Semiconductor

Codice articolo simile - 74ACQ464ASPC

Descrizione simile - 74ACQ464ASPC

Html Pages

1 2 3 4 5 6 7 8 9 10

Scheda tecnica Scarica

Link URL