Motore di ricerca datesheet componenti elettronici
  Italian  ▼
ALLDATASHEETIT.COM

X  

AD8348-EVAL Scheda tecnica(PDF) 8 Page - Analog Devices

Il numero della parte AD8348-EVAL
Spiegazioni elettronici  50-1000 MHz Quadrature Demodulator
Download  13 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Produttore elettronici  AD [Analog Devices]
Homepage  http://www.analog.com
Logo AD - Analog Devices

AD8348-EVAL Scheda tecnica(HTML) 8 Page - Analog Devices

Back Button AD8348-EVAL Datasheet HTML 4Page - Analog Devices AD8348-EVAL Datasheet HTML 5Page - Analog Devices AD8348-EVAL Datasheet HTML 6Page - Analog Devices AD8348-EVAL Datasheet HTML 7Page - Analog Devices AD8348-EVAL Datasheet HTML 8Page - Analog Devices AD8348-EVAL Datasheet HTML 9Page - Analog Devices AD8348-EVAL Datasheet HTML 10Page - Analog Devices AD8348-EVAL Datasheet HTML 11Page - Analog Devices AD8348-EVAL Datasheet HTML 12Page - Analog Devices Next Button
Zoom Inzoom in Zoom Outzoom out
 8 / 13 page
background image
PRELIMINARY TECHNICAL DATA
Rev. PrF 2/11/03
- 8 -
Applications
Basic Connections
The basic connections described here refer to the AD8348
evaluation board. The schematic for the evaluation board is
shown in Figure 1.
Power Supply
The voltage supply for the AD8348, between 2.7V and 5V,
should be connected to the +Vs test point and ground should
be connected to one of the GND test points.
Device Enable
To enable the device, the pin ENBL should be driven to +Vs.
Grounding the same pin will disable the device. On the
evaluation board this can be achieved by moving SW11 to the
ENBL and DENBL positions respectively.
VGA Enable
The VGA can be enabled by driving the voltage on the pin
ENVG to +Vs. In this mode, the MX inputs are disabled and
the IF inputs should be utilized. Grounding the pin will
disable the VGA and the IF inputs. When the VGA is
disabled the MX inputs should be used. On the evaluation
board, SW12 should be positioned in either the IF or MX
positions.
Gain Control
When the VGA is enabled, the gain can be controlled by the
voltage on pin VGIN. The gain control voltage range is
between 0.2 V and 1.2 V. This corresponds to a gain range
between 25.6 dB and –18.3 dB. For convenience, a
potentiometer R15 is provided to allow for changes in gain
without the need for an additional DC voltage source. To use
the potentiometer, the switch SW13 must be set to the POT
position. Alternatively, an external voltage applied to either
the testpoint or SMA connector labeled VGIN can set the
gain. SW13 must be set to the EXT position when an external
gain control voltage is used.
LO Input
The local oscillator signal should be fed to the SMA connector
J21. This port is terminated in 50 Ohms. The recommended
LO drive level is between –10 and 0 dBm. The LO frequency
at the input to the device should be twice that of the desired
LO frequency at the mixer core. The applied LO frequency
range is between 100 MHz and 2 GHz.
IF Input
The IF input should be fed into the SMA connector IFIP. The
VGA must be enabled when this port is used (SW12 in the IF
position).
MX Input
The input to the mixer input can be either single-ended or
differential. The evaluation board is, by default, set for
single-ended MX drive. To change to a differential drive, T41
should be removed along with resistor R42. DC blocking
capacitors (C42, C43) should be installed in place of T41.
This will present a nominal differential impedance of 200
Ohms (100 Ohms each side). The differential inputs should
then be fed into SMA connectors MXIP and MXIN.
Baseband Outputs
The baseband outputs are at the IOPP, IOPN, QOPP and
QOPN testpoints and SMA connectors. These outputs are not
designed to drive 50 Ohm loads directly and should be
presented with loads of at least 2k Ohms.
Output DC Bias Level
The DC bias level of the baseband amplifier outputs are by
default tied to Vref through LK11. If desired, the DC bias
level can be changed by removing LK11 and driving a DC
voltage onto either the VCMO testpoint.
AD8348


Codice articolo simile - AD8348-EVAL

Produttore elettroniciIl numero della parteScheda tecnicaSpiegazioni elettronici
logo
Analog Devices
AD8348 AD-AD8348 Datasheet
2Mb / 20P
   300 MHz to 1000 MHz Quadrature Modulator
REV. 0
AD8348 AD-AD8348 Datasheet
2Mb / 32P
   400 MHz to 6 GHz Broadband Quadrature Modulator
REV. 0
AD8348 AD-AD8348 Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
AD8348ARUZ AD-AD8348ARUZ Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
AD8348ARUZ-REEL7 AD-AD8348ARUZ-REEL7 Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
More results

Descrizione simile - AD8348-EVAL

Produttore elettroniciIl numero della parteScheda tecnicaSpiegazioni elettronici
logo
Analog Devices
AD8348 AD-AD8348_15 Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
AD8348ARUZ-REEL7 AD-AD8348ARUZ-REEL7 Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
AD8348ARUZ AD-AD8348ARUZ Datasheet
929Kb / 28P
   50 MHz to 1000 MHz Quadrature Demodulator
REV. A
logo
TEMIC Semiconductors
U2791B TEMIC-U2791B Datasheet
257Kb / 11P
   1000 MHz Quadrature Demodulator
logo
ATMEL Corporation
U2794B ATMEL-U2794B_08 Datasheet
923Kb / 15P
   1000-MHz Quadrature Demodulator
U2794B ATMEL-U2794B Datasheet
290Kb / 15P
   1000 MHZ QUADRATURE DEMODULATOR
logo
TEMIC Semiconductors
U2794B TEMIC-U2794B Datasheet
258Kb / 11P
   1000 MHz Quadrature Demodulator
logo
Analog Devices
ADL5387 AD-ADL5387 Datasheet
761Kb / 28P
   50 MHz to 2 GHz Quadrature Demodulator
REV. 0
logo
ATMEL Corporation
U2790B ATMEL-U2790B Datasheet
228Kb / 15P
   1000-MHz QUADRATURE MODULATOR
logo
SIRENZA MICRODEVICES
SRQ-2116Z SIRENZA-SRQ-2116Z Datasheet
196Kb / 16P
   700-3800 MHz Direct Quadrature Demodulator
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13


Scheda tecnica Scarica

Go To PDF Page


Link URL




Privacy Policy
ALLDATASHEETIT.COM
Lei ha avuto il aiuto da alldatasheet?  [ DONATE ] 

Di alldatasheet   |   Richest di pubblicita   |   contatti   |   Privacy Policy   |   scambio Link   |   Ricerca produttore
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com