Motore di ricerca datesheet componenti elettronici
  Italian  ▼
ALLDATASHEETIT.COM

X  

ISL54224IRTZ Scheda tecnica(PDF) 11 Page - Intersil Corporation

Il numero della parte ISL54224IRTZ
Spiegazioni elettronici  High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP) and Overvoltage Indicator Output
Download  18 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Produttore elettronici  INTERSIL [Intersil Corporation]
Homepage  http://www.intersil.com/cda/home
Logo INTERSIL - Intersil Corporation

ISL54224IRTZ Scheda tecnica(HTML) 11 Page - Intersil Corporation

Back Button ISL54224IRTZ Datasheet HTML 7Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 8Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 9Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 10Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 11Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 12Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 13Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 14Page - Intersil Corporation ISL54224IRTZ Datasheet HTML 15Page - Intersil Corporation Next Button
Zoom Inzoom in Zoom Outzoom out
 11 / 18 page
background image
11
FN6969.0
June 7, 2010
For lowest power consumption you should use the lowest
VDD supply.
A 0.01µF or 0.1µF decoupling capacitor should be
connected from the VDD pin to ground to filter out any
power supply noise from entering the part. The
capacitor should be located as close to the VDD pin as
possible.
In a typical application, VDD will be in the range of
2.8V to 4.3V and will be connected to the battery or
LDO of the portable media device.
LOGIC CONTROL
The state of the ISL54224 device is determined by the
voltage at the SEL pin and the OE/ALM pin. SEL is only
active when the OE/ALM pin is logic “1” (High). Refer to
“Truth Table” on page 2.
The ISL54224 logic pins are designed to minimize
current consumption when the logic control voltage is
lower than the VDD supply voltage. With VDD = 3.6V and
logic pins at 1.4V the part typically draws only 25µA.
With VDD = 4.3V and logic pins at 2.6V the part typically
draws only 35µA. Driving the logic pins to the VDD supply
rail minimizes power consumption.
The SEL pin and OE/ALM pin have special circuitry that
allows them to be driven with a voltage higher than the
VDD supply voltage. These pins can be driven up to
5.25V with a VDD supply in the range of 2.7V to 5.25V.
The SEL pin and OE/ALM pin are internally pulled low
through 4MΩ resistors to ground and can be tri-stated by
a µProcessor.
The OE/ALM pin is an open drain connection. It should be
pulled high through an external 100kΩ pull-up resistor.
The OE/ALM pin can then be driven “Low” by a
µProcessor to open all switches or it can be monitored by
the µProcessor for a “Low” when the part goes into an
over-voltage condition.
Logic Control Voltage Levels
HSD1 USB Channel
If the SEL pin = Logic “0” and the OE/ALM pin = Logic
“1”, high-speed Channel 1 will be ON. The HSD1- and
HSD1+ switches are ON and the HSD2- and HSD2+
switches are OFF (high impedance).
When a computer or USB hub is plugged into the
common USB connector and Channel 1 is active, a link
will be established between the USB 1 transceiver section
of the media player and the computer. The device will be
able to transmit and receive data from the computer.
HSD2 USB Channel
If the SEL pin = Logic “1” and the OE/ALM pin = Logic
“1”, high-speed Channel 2 will be ON. The HSD2- and
HSD2+ switches are ON and the HSD1- and HSD1+
switches are OFF (high impedance).
When a USB cable from a computer or USB hub is
connected at the common USB connector and Channel 2
is active, a link will be established between the USB 2
driver section of the media player and the computer. The
device will be able to transmit and receive data from the
computer.
All Switches OFF Mode
If the SEL pin = Logic “0” or Logic “1” and the OE/ALM
pin = Logic “0”, all of the switches will turn OFF (high
impedance).
The all OFF state can be used to switch between the two
USB sections of the media player. When disconnecting
from one USB device to the other USB device, you can
momentarily put the ISL54224 switch in the “all off”
state in order to get the computer to disconnect from
the one device so it can properly connect to the other
USB device when that channel is turned ON.
Whenever the ISL54224 senses a fault condition on the
COM pins, the OE/ALM pin will be internal pulled low by
the device and all switches will be turned OFF.
USB 2.0 VBUS Short Requirements
The USB specification in section 7.1.1 states a USB
device must be able to withstand a VBUS short (4.4V to
5.25V) or a -1V short to the D+ or D- signal lines when
the device is either powered off or powered on for at
least 24 hours.
The ISL54224 part has special power-off protection and
OVP detection circuitry to meet these short circuit
requirements. This circuitry allows the ISL54224 to
provide protection to the USB down-stream transceivers
connected at its signal pins (HS1D-, HS1D+, HS2D-,
HS2D+) to meet the USB specification short circuit
requirements.
The power-off protection and OVP circuitry allows the
COM pins (D-, D+) to be driven up to 5.25V or down to
-5V while the VDD supply voltage is in the range of 0V to
5.25V. In these overvoltage conditions with a 500Ω
external VDD resistor the part draws < 55µA of current
into the COM pins and causes no stress/damage to the
IC. In addition, all switches are OFF and the shorted
VBUS voltage will be isolated from getting through to the
other side of the switch channels, thereby protecting the
USB transceivers.
TABLE 2. LOGIC CONTROL VOLTAGE LEVELS
VDD
SUPPLY
RANGE
LOGIC = “0” (LOW) LOGIC = “1” (HIGH)
OE/ALM
SEL
OE/ALM
SEL
2.7V to 3.6V
≤ 0.5V
or floating
≤ 0.5V
or floating
≥1.4V
≥1.4V
3.7V to 4.2V
≤ 0.7V
or floating
≤ 0.7V
or floating
≥1.7V
≥1.7V
4.3V to 5.25V
≤ 0.8V
or floating
≤ 0.8V
or floating
≥2.0V
≥2.0V
ISL54224


Codice articolo simile - ISL54224IRTZ

Produttore elettroniciIl numero della parteScheda tecnicaSpiegazioni elettronici
logo
Renesas Technology Corp
ISL54224IRTZ RENESAS-ISL54224IRTZ Datasheet
1,019Kb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP) and Overvoltage Indicator Output
ISL54224IRTZ-T RENESAS-ISL54224IRTZ-T Datasheet
1,019Kb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP) and Overvoltage Indicator Output
More results

Descrizione simile - ISL54224IRTZ

Produttore elettroniciIl numero della parteScheda tecnicaSpiegazioni elettronici
logo
Renesas Technology Corp
ISL54224 RENESAS-ISL54224 Datasheet
1,019Kb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP) and Overvoltage Indicator Output
ISL54225 RENESAS-ISL54225 Datasheet
1Mb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP)
logo
Intersil Corporation
ISL54225 INTERSIL-ISL54225_10 Datasheet
758Kb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer with Overvoltage Protection (OVP)
ISL54228 INTERSIL-ISL54228 Datasheet
738Kb / 17P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP)
logo
Renesas Technology Corp
ISL54228 RENESAS-ISL54228 Datasheet
1Mb / 17P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP)
ISL54227 RENESAS-ISL54227 Datasheet
1Mb / 18P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP) and Dedicated Charger Port Detection
logo
Intersil Corporation
ISL54226 INTERSIL-ISL54226_10 Datasheet
784Kb / 18P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP) and Dedicated Charger Port Detection
ISL54227 INTERSIL-ISL54227_10 Datasheet
785Kb / 18P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP) and Dedicated Charger Port Detection
logo
Renesas Technology Corp
ISL54226 RENESAS-ISL54226 Datasheet
1Mb / 17P
   High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP) and Dedicated Charger Port Detection
ISL54220 RENESAS-ISL54220 Datasheet
1Mb / 18P
   High-Speed USB 2.0 (480Mbps) Multiplexer
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18


Scheda tecnica Scarica

Go To PDF Page


Link URL




Privacy Policy
ALLDATASHEETIT.COM
Lei ha avuto il aiuto da alldatasheet?  [ DONATE ] 

Di alldatasheet   |   Richest di pubblicita   |   contatti   |   Privacy Policy   |   scambio Link   |   Ricerca produttore
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com