MC10H209

http://onsemi.com

2

Table 1. MAXIMUM RATINGS

Symbol

Characteristic

Rating

Unit

−8.0 to 0

Vdc

Vdc

Output Current

− Continuous

− Surge

50

100

mA

Operating Temperature Range

0 to +75

°C

Storage Temperature Range − Plastic

− Ceramic

−55 to +150

−55 to +165

°C

°C

Maximum ratings are those values beyond which device damage can occur. Maximum ratings applied to the device are individual stress limit

values (not normal operating conditions) and are not valid simultaneously. If these limits are exceeded, device functional operation is not implied,

damage may occur and reliability may be affected.

0°

25°

75°

Symbol

Characteristic

Min

Max

Min

Max

Min

Max

Unit

Power Supply Current

−

−

−

30

−

−

mA

Input Current High

−

640

−

400

−

400

mA

Input Current Low

0.5

−

0.5

−

0.3

−

mA

High Output Voltage

−1.02

−0.84

−0.98

−0.81

−0.92

−0.735

Vdc

Low Output Voltage

−1.95

−1.63

−1.95

−1.63

−1.95

−1.60

Vdc

High Input Voltage

−1.17

−0.84

−1.13

−0.81

−1.07

−0.735

Vdc

Low Input Voltage

−1.95

−1.48

−1.95

−1.48

−1.95

−1.45

Vdc

1. Each MECL 10H™ series circuit has been designed to meet the dc specifications shown in the test table, after thermal equilibrium has been

established. The circuit is in a test socket or mounted on a printed circuit board and transverse air flow greater than 500 lfpm is maintained.

Outputs are terminated through a 50 W resistor to −2.0 V.

Table 3. AC PARAMETERS

0°

25°

75°

Symbol

Characteristic

Min

Max

Min

Max

Min

Max

Unit

Propagation Delay

0.4

1.15

0.4

1.15

0.4

1.15

ns

Rise Time

0.4

1.5

0.4

1.5

0.4

1.6

ns

Fall Time

0.4

1.5

0.4

1.5

0.4

1.6

ns

NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit

board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared

operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit

values are applied individually under normal operating conditions and not valid simultaneously.