Datasheet

Datasheet

20/22

TSZ02201-0H1H0B101200-1-2

© 2014 ROHM Co., Ltd. All rights reserved.

www.rohm.com

TSZ22111 • 15 • 001

BD63241FV

3.Mar.2015 Rev.001

Operational Notes

1.

Reverse Connection of Power Supply

Connecting the power supply in reverse polarity can damage the IC. Take precautions against reverse polarity when

connecting the power supply, such as mounting an external diode between the power supply and the IC’s power

supply pins.

2.

Power Supply Lines

Design the PCB layout pattern to provide low impedance supply lines. Separate the ground and supply lines of the

digital and analog blocks to prevent noise in the ground and supply lines of the digital block from affecting the analog

block. Furthermore, connect a capacitor to ground at all power supply pins. Consider the effect of temperature and

aging on the capacitance value when using electrolytic capacitors.

3.

Ground Voltage

Ensure that no pins are at a voltage below that of the ground pin at any time, even during transient condition. However,

pins that drive inductive loads (e.g. motor driver outputs, DC-DC converter outputs) may inevitably go below ground

due to back EMF or electromotive force. In such cases, the user should make sure that such voltages going below

ground will not cause the IC and the system to malfunction by examining carefully all relevant factors and conditions

such as motor characteristics, supply voltage, operating frequency and PCB wiring to name a few.

4.

Ground Wiring Pattern

When using both small-signal and large-current ground traces, the two ground traces should be routed separately but

connected to a single ground at the reference point of the application board to avoid fluctuations in the small-signal

ground caused by large currents. Also ensure that the ground traces of external components do not cause variations

on the ground voltage. The ground lines must be as short and thick as possible to reduce line impedance.

5.

Thermal Consideration

Should by any chance the power dissipation rating be exceeded the rise in temperature of the chip may result in

deterioration of the properties of the chip. The absolute maximum rating of the Pd stated in this specification is when

the IC is mounted on a 74.2mm x 74.2mm x 1.6mm glass epoxy board. In case of exceeding this absolute maximum

rating, increase the board size and copper area to prevent exceeding the Pd rating.

6.

Recommended Operating Conditions

These conditions represent a range within which the expected characteristics of the IC can be approximately obtained.

The electrical characteristics are guaranteed under the conditions of each parameter.

7.

Inrush Current

When power is first supplied to the IC, it is possible that the internal logic may be unstable and inrush

current may flow instantaneously due to the internal powering sequence and delays, especially if the IC

has more than one power supply. Therefore, give special consideration to power coupling capacitance,

power wiring, width of ground wiring, and routing of connections.

8.

Operation Under Strong Electromagnetic Field

Operating the IC in the presence of a strong electromagnetic field may cause the IC to malfunction.

9.

Testing on Application Boards

When testing the IC on an application board, connecting a capacitor directly to a low-impedance output pin may

subject the IC to stress. Always discharge capacitors completely after each process or step. The IC’s power supply

should always be turned off completely before connecting or removing it from the test setup during the inspection

process. To prevent damage from static discharge, ground the IC during assembly and use similar precautions during

transport and storage.

10.

Inter-pin Short and Mounting Errors

Ensure that the direction and position are correct when mounting the IC on the PCB. Incorrect mounting may result in

damaging the IC. Avoid nearby pins being shorted to each other especially to ground, power supply and output pin.

Inter-pin shorts could be due to many reasons such as metal particles, water droplets (in very humid environment) and

unintentional solder bridge deposited in between pins during assembly to name a few.