Motore di ricerca datesheet componenti elettronici |
|
BU21026MUV Scheda tecnica(PDF) 5 Page - Rohm |
|
BU21026MUV Scheda tecnica(HTML) 5 Page - Rohm |
5 / 23 page 5/19 TSZ02201-0L5L0FF00890-1-2 © 2016 ROHM Co., Ltd. All rights reserved. 4.Aug.2016 Rev.001 www.rohm.com TSZ22111 • 15 • 001 BU21026MUV Touch Detection A touch detection function of BU21026MUV is automatically enabled after wakeup. BU21026MUV inform that touch screen is touched or not by INT pin when touch detection is enabled. Output level of INT becomes low during screen is touched. In this state, XP pin is pulled-up high by pull-up resistor (RPU) and YN pin is connected to GND. A resistance of RPU is selectable from either 50 kohm (default) or 90 kohm by the setup command. When the screen isn’t touched, XP is connected to VDD trough the pull-up resistor. When the screen is touched, XP is connected to GND trough the screen and BU21026MUV detect touch. When a received command is not setup (1011), the touch detection is disabled and RPU is disconnected from XP pin. And output level of INT is fixed high or low by each command (see Table 3 for details about operation code). When BU21026MUV receives software reset command (0101), touch detection is enabled after the 2 nd acknowledge timing. When BU21026MUV receives A/D conversion with PD=0 command touch detection is enabled after an A/D conversion is finished. When BU21026MUV receives a driving screen voltage or an A/D conversion with PD=1 command, touch detection is not enable automatically. A method for re-enable the touch detection is sending new command that return to enable touch detection. The set power command is almost same as an A/D conversion command. ON GND XP YP XN YN ON RPU INT VDD OFF Control logic Touch Detection Circuit Digital Filter BU21026MUV has a Median Average Filter (MAF) as a digital filter for noise reduction. When the MAF is enabled, BU21026MUV operates A/D conversion 7 times and stores converted data. Next, these stored data are sorted. An output data of MAF is an average value of middle three values of the sorted data. An abnormal value becomes difficult to affect the results. So noise reduction performance of MAF is higher than one of normal average filter. When the MAF is disabled, BU21026MUV operates A/D conversion one times and output the converted data The MAF is enabled in defaults and is changed by the setup command. |
Codice articolo simile - BU21026MUV |
|
Descrizione simile - BU21026MUV |
|
|
Link URL |
Privacy Policy |
ALLDATASHEETIT.COM |
Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |