SN54ABT8543, SN74ABT8543

SCAN TEST DEVICES WITH

OCTAL REGISTERED BUS TRANSCEIVERS

SCBS120E – AUGUST 1991 – REVISED JULY 1996

11

POST OFFICE BOX 655303

control boundary to high impedance

This instruction conforms to the IEEE Standard 1149.1a-1993 HIGHZ instruction. The bypass register is

selected in the scan path. A logic 0 value is captured in the bypass register during Capture-DR. The device

operates in a modified test mode in which all device I/O pins are placed in the high-impedance state, the device

input pins remain operational, and the normal on-chip logic function is performed.

control boundary to 1/0

This instruction conforms to the IEEE Standard 1149.1a-1993 CLAMP instruction. The bypass register is

selected in the scan path. A logic 0 value is captured in the bypass register during Capture-DR. Data in the input

BSCs is applied to the inputs of the normal on-chip logic, while data in the output BSCs is applied to the device

output pins. The device operates in the test mode.

boundary run test

The bypass register is selected in the scan path. A logic 0 value is captured in the bypass register during

Capture-DR. The device operates in the test mode. The test operation specified in the BCR is executed during

Run-Test/Idle. The five test operations decoded by the BCR are: sample inputs/toggle outputs (TOPSIP),

PRPG, PSA, simultaneous PSA and PRPG (PSA/PRPG), and simultaneous PSA and binary count up

(PSA/COUNT).

boundary read

The BSR is selected in the scan path. The value in the BSR remains unchanged during Capture-DR. This

instruction is useful for inspecting data after a PSA operation.

boundary self test

The BSR is selected in the scan path. All BSCs capture the inverse of their current values during Capture-DR.

In this way, the contents of the shadow latches can be read out to verify the integrity of both shift-register and

shadow-latch elements of the BSR. The device operates in the normal mode.

boundary toggle outputs

The bypass register is selected in the scan path. A logic 0 value is captured in the bypass register during

Capture-DR. Data in the shift-register elements of the selected output BSCs is toggled on each rising edge of

TCK in Run-Test/Idle, updated in the shadow latches, and applied to the associated device output pins on each

falling edge of TCK in Run-Test/Idle. Data in the selected input BSCs remains constant and is applied to the

inputs of the normal on-chip logic. Data appearing at the device input pins is not captured in the input BSCs.

The device operates in the test mode.

boundary-control-register scan

The BCR is selected in the scan path. The value in the BCR remains unchanged during Capture-DR. This

operation must be performed before a boundary-run test operation to specify which test operation is to

be executed.