Motore di ricerca datesheet componenti elettronici |
|
TL22 Scheda tecnica(PDF) 3 Page - 3M Electronics |
|
TL22 Scheda tecnica(HTML) 3 Page - 3M Electronics |
3 / 4 page 3M™ Scotch-Weld™ Threadlocker Anaerobic Adhesives TL22 • TL42 • TL43 • TL62 • TL71 • TL72 • TL77 • TL90 - 3 - Directions for Use 3M™ Scotch-Weld™ Threadlocker Anaerobic Adhesives are not recommended for use on most plastics due to potential cracking of plastic parts. Also, they are not recommended for use in piping systems that contain pure oxygen or an oxygen-rich environment, chlorine, or strong oxidizing substances. For Assembly 1. Ensure parts are clean, dry and free from oil, grease and dirt. For best results, clean and dry parts with solvent or 3M™ Scotch-Weld™ Activator. (Activator can also be used on inactive surfaces or to accelerate the cure on active surfaces.) 2. If not sure of surface type, always use activator. Refer to Material Surface Activity and Cure Speed section for more information. 3. Shake the adhesive bottle well before use. 4. Avoid touching the metal surfaces with the bottle tip since the metal ions may react with the adhesive upon contact and eventually may clog the bottle tip. 5. Apply adhesive onto the threaded part where the contact area will be in the final assembly. For larger parts, use more adhesive and rotate the threaded part to spread adhesive evenly around contact area. 6. For through holes, apply several drops of adhesive onto the bolt at the nut engagement area. For blind holes, apply several drops of the adhesive down the internal threads to the bottom of the hole. 7. Assemble the nut/fastener and tighten as required. 8. Allow assemblies to set for sufficient time so that handling strength or full cure will occur before further processing or testing. For Disassembly 1. Loosen or remove with regular hand tools. 2. If hand tools do not work due to the assembled parts being well tightened, apply localized heat (approximately 490°F) to the nut or bolt and disassemble while parts are still hot. Use extreme caution when working with heat sources (e.g. heat gun, flames, etc. Handling Information Active (Fast) Inactive (Slow) Material Surface Activity and Cure Speed • Brass • Bronze • Commercial aluminum • Copper • Iron •Kovar ® • Manganese • Monel ® • Nickel • Anodized aluminum • Cadmium • Chemical black oxide • Galvanized steel • Gold • Inconel ® • Magnesium • Magnetite steel • Plated parts • Pure aluminum • Silver • Stainless steel •Zinc |
Codice articolo simile - TL22 |
|
Descrizione simile - TL22 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEETIT.COM |
Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |