Data Sheet PG10674EJ01V0DS

4

MC-7896

NOTES ON CORRECT USE

(1) The space between PC board and root of the lead should be kept more than 1 mm to prevent undesired stress

to the lead and also should be kept less than 4 mm to prevent undesired parasitic inductance.

Recommended that space is 2.0 to 3.0 mm typical.

(2) Recommended torque strength of the screw is 59 to 78 Ncm.

(3) Form the ground pattern as wide as possible to minimize ground impedance.

(to prevent undesired oscillation)

All the ground pins must be connected together with wide ground pattern to decrease impedance difference.

RECOMMENDED SOLDERING CONDITIONS

This product should be soldered and mounted under the following recommended conditions.

For soldering

methods and conditions other than those recommended below, contact your nearby sales office.

Soldering Method

Soldering Conditions

Recommended Condition Symbol

Partial Heating

Peak temperature (pin temperature) : 350

Soldering time (per pin of device)

: 3 seconds or less

−

Note The point of pin part heating must be kept more than 1.2 mm distance from the root of lead.