PS No. 5760-9/9

LC7535M

This catalog provides information as of May, 1998. Specifications and information herein are subject to change

without notice.

s No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace

equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of

which may directly or indirectly cause injury, death or property loss.

s Anyone purchasing any products described or contained herein for an above-mentioned use shall:

ΠAccept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and

distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all

damages, cost and expenses associated with such use:

 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on

SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees

jointly or severally.

s Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for

volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied

regarding its use or any infringements of intellectual property rights or other rights of third parties.

Usage Notes

• The state of the internal analog switches are undefined when power is first applied. Applications should apply external

muting to the output signal until the control data has been set up.

• To prevent the high-frequency digital signals transmitted over the CL, DI, and CE pin lines from entering the analog

signal system, these lines should either be covered by the ground pattern or shielded cables should be used.

80-kHz low-pass weighting

Flat overall

THD – Output Level Characteristics (1)

80-kHz low-pass weighting

Volume control set to –20 dB

THD – Output Level Characteristics (2)